REO Town Band Camera Checklist

Before Service

  1. Insert SD card from black production bin
    1. Open SD card access door at the back left corner of the camera.
    2. Insert card into slot and press until seated in camera.
    3. Close SD card access door.
  2. Power on camera by pressing the power button on the left side
  3. Power on microphone by sliding the front switch on the microphone’s left side
    1. Power switch will glow green with the microphone is powered.
    2. If the microphone doesn’t power on, try changing the batteries by sliding the switch on the back of the microphone down. (Requires 2-AAA Batteries)
  4. Confirm settings on the left side of microphone
    1. Sensitivity set to lowest setting (switch pushed furthest to the left).
    2. Low-cut filter is set to off (switch pushed furthest to the right).

5 Minutes Before Service Starts

  1. Start recording by pressing the red button on the back of the camera
    1. Stop recording during the announcements before the message.
    2. Start recording again during the prayer at the end of the message.
    3. Stop recording after the last song, or band outro if applicable.

After Service

  1. Power off camera by holding down the power button on the left side of the camera
    1. Display on camera will turn off when camera is powered down.
  2. Power off microphone by sliding front switch on microphone’s left side
    1. Power switch on microphone will stop glowing green when powered off.
  3. Remove SD Card
    1. Open SD card access door at the back left corner of the camera.
    2. Press on SD card to eject from camera. Remove SD card from camera.
    3. Close SD card access door.
  4. Place SD card in black production bin

REO Town Band Camera 01

REO Town Band Camera 02

REO Town Band Camera 03